Description
FEATURES
The CI-IWHDMON is a state-of-the-art in-wall speaker system providing upscale performance and exceptional room filling intelligibility at low distortion levels. At the heart of its design are (2) cast frame 7” Norwegian Reed Cone woofers with extremely high stiffness exhibiting fast decay and damping. Stiffness provides leading edge accuracy, while damping provides clarity. Music has a more “being there” experience. This advanced cone assembly, acting as “pure piston” up to 2 kHz, is driven by a focused field, high magnetic flux, magnet/motor system with embedded internal shorting rings to minimize distortion. These shorting rings act as a governor to optimize and control the “in-and-out” movement of the cone assembly, while also providing a dynamic heat sink. This means the CI-IWHDMON exhibits high-power, wide dynamic range, lifelike – loud SPL capability and minimal compression.
A ¾” thick MDF driver mount baffle is internally affixed to a computer mapped system of rigid circumferential braces. The remaining five panels (sides, t-b, and rear) are a complex arrangement of interlocking rigid materials with varying acoustic properties that complement each other. This synergized enclosure network reduces resonance rendering the cabinet/enclosure itself essentially inert (i.e. the enclosure doesn’t “move”).
A minimum phase optimized crossover is matched to a 1” pure Scandinavian silk dome tweeter, with an aperiodic (highly damped) rear chamber, for seamless integration and matchless purity in the upper midrange and high frequencies.
| SPECS DESCRIPTION | SPECS |
| System Design | Two-Way Reference grade in-wall LCR |
| Enclosure | Sealed |
| Woofer | (2) 7 ” Reed cone |
| Tweeter | (1) 1″ Dyna |
| Recommended Amp Power | 50-400 W |
| Frequency Response | 40 Hz – 20 kHz |
| Anechoic Frequency Response | 43 Hz – 20 kHz +- 3 db |
| Impedance | 4 ohms |
| Sensitivity (db 1 watt/1 meter) | 90 |
| Hole Cut Out | 11” x 28’ x 5″d |
| Overall Size | 12” x 29” |
| Standard Finish | Black Pro Duratex |
Next Level preconstruction brackets come with (2) grooves cut into the outside edge of the front face with mounting hardware and perforated metal securing plates. Please follow the below steps:
- Lay the preconstruction bracket on its back with the grooves facing upward
- Using the small silver #6 screws (supplied), install a single perforated metal plate into each of the (2) grooves using the 2 screws
- Move the assembly with the plates attached to the desired location on the wall and secure to the studs (front facing outward) using the 1” wood screws (provided)
- Drywall over the assembly and router out the inner section of drywall to where the preconstruction bracket starts exposing the opening for the speaker
