Description
FEATURES
- Weather resistant
- Wide dynamic range
- Smooth frequency response
- Enhanced room coupling
- High dialogue intelligibility
- Easy integration
- Custom configurations (Stereo vs. LCR vs. Center) and widths
| System Type and Configuration | (3) Sector LCR, Sealed, WTW, WTW, WTW or WTW, WTW (Stereo) |
| Woofers | (6) 4.5″ Drivers |
| Tweeters | (3) BC Tweeters |
| Sensitivity | 92 dB at 1 W- 1 M |
| Impedance | 4 ohms |
| Response | 50 Hz – 20 Khz |
| Power- Min/Max – RMS | 25/300 |
| Dimensions | 5.5″ h x 3.5″ d x custom″ w |
| Standard Finish | Pro Black Duratex |
***Follow the Z-Clip installation instructions***
1. Please keep your boxes and inner packaging materials. In the event that your speakers need to be serviced at the factory it is essential they are returned in their original packaging.
2. If wall mounting the LCR, install rubber bumpers and Z Clips. Z Clips mount “tab down” (screws on the top) and “tab up” (screws on the bottom) on the wall. Do not mount the Z Clips where the non-safe zones are indicated on the back of the unit.
3. Install hookup wires. Observe polarity to and from the receiver amplifier to the speaker. (+) Side of the peaker must connect to the (+) side of the amplifier. I.e. red to + and black to (-). Place either directly above or below the display.
4. Break-in normally takes about 12 hours of playing. In this 12 hours, the crossover capacitors and drive units are breaking in. Please do not play at excessive power levels. Over-driving the speaker system can result in permanent damage. Always turn down the volume when changing between program sources.
