Description
FEATURES
- High-output Cinematic Performance disguised as a mantel
- WTW, WTW, WTW (LCR) Configuration
- WTW, WTW (Stereo) Configuration
- 4×4 compression horn system
- Proprietary crossover design
- Precision CNC Construction
- Custom″ wide x 5.75″ deep x 7.5″ high
- Custom finishes, designer grille fabrics, and colors available upon request
| System Type and Configuration | (3) Sector LCR, Sealed, WTW, WTW, WTW / Stereo WTW, WTW |
| Woofers | (6) 6.5″ Drivers (LCR)/ (4) 6.5″ Drivers (Stereo) |
| Tweeters | (3) 4×4 Compression Horn (LCR) / (2) 4×4 Compression Horn (Stereo) |
| Sensitivity / Max SPL | 93 dB at 1 W- 1 M / 104 dB at 1 W – 1 M |
| Impedance | 4 ohms each sector |
| Response | 45 Hz – 20 kHz |
| Power- Min/Max – RMS | 50 – 500 |
| Dimensions | Custom” wide x 5.75″ deep x 7.5″ high |
| Standard Finishes | High Gloss Black / Matte Black / Oak w/ Black Lacquer (up to 85″ displays) |
***Z-CLIP WALL MOUNT INSTALLATION ONLY DUE TO SIZE AND WEIGHT***
1. Please keep your boxes and inner packaging materials. In the event that your speakers need to be serviced at the factory it is essential they are returned in their original packaging.
2. If wall mounting the LCR, install rubber bumpers and Z Clips. Z Clips mount “tab down” (screws on the top) and “tab up” (screws on the bottom) on the wall.
3. Install hookup wires. Observe polarity to and from the receiver amplifier to the speaker. (+) Side of the speaker must connect to the (+) side of the amplifier. I.e. red to + and black to (-). Place either directly above or below the display.
4. Break-in normally takes about 12 hours of playing. In this 12 hours, the crossover capacitors and drive units are breaking in. Please do not play at excessive power levels. Over-driving the speaker system can result in permanent damage. Always turn down the volume when changing between program sources.
